NomadPort

🔥 NomadPort Magnetic Tent Passthrough Ring

Field-tested. Camp-ready.
The NomadPort is your permanent, low-profile solution for bringing warmth — or airflow — into your tent without compromising structure, storage, or sanity. Designed for overlanders, campers, and anyone who refuses to settle for duct tape and drafty gaps, NomadPort delivers a modular, magnetic passthrough system that just works.

After months of field use, multiple camping trips, and full-season storage, NomadPort has proven itself: no warping, no tearing, and no fumbling in the cold.

🔑 Key Features

🧲 Magnetic, Modular Design

Two interlocking rings made from rugged white ASA sandwich your tent's mesh fabric, creating a permanent passthrough port that's both strain-relieving and self-aligning thanks to eight embedded neodymium magnets in an octagonal array.

🔥 Heat-Resistant and Weatherproof

ASA plastic shrugs off sun, wind, rain, and heat. The system holds strong through heater cycles and months of roll-up storage inside your tent without deforming or degrading.

🧼 Insect-Blocking Magnetic Cover (Optional)

Snap on the low-profile NomadCap to seal the passthrough when not in use — keeping bugs, dirt, and debris out while your tent is packed or ventless.

🛠️ Zero-Tool Install, Permanent Fit

Magnets hold the rings in place while your adhesive of choice sets. Once bonded, the passthrough becomes a seamless part of your tent — no screws, no sewing, no regrets.

🧳 Low-Profile, Roll-Up Friendly

Designed to sit flat and flex with your tent, NomadPort adds functionality without bulk. Roll it. Store it. Deploy it again. It just works.

🔹 What's Included:

• 2 interlocking ASA passthrough rings (top + bottom)
• 8 pre-installed neodymium magnets (press-fit) on each side

🔧 What You'll Need (Not Included):

A small amount of super glue (cyanoacrylate) to permanently bond the rings to your tent fabric. Any hardware store CA glue will do the job. We recommend a gel formula over thin liquid — gel stays where you put it on mesh instead of wicking through the weave. One small tube is plenty for a single install.

💬 Real-World Tested

"After rolling this up in my tent bag for months and taking it through multiple camping trips — it still looks and performs like new. The heater vent setup is solid, and I finally sleep warm without worrying about fabric tears or bugs crawling through an open zipper"
– User Prime, California

⚠️ Safety & Responsibility

NomadPort is a passthrough accessory. It is not a heater, not a combustion or exhaust component, and not a certified safety device. It does not make any heater safe to run in or near an enclosed space.

• Always follow your heater manufacturer's instructions.
• Keep heater exhaust outside the tent and away from fabric.
• Maintain proper ventilation and run a working carbon monoxide detector any time a heater is used in or near an enclosed space.
• Installation permanently modifies your tent. Bonding, cutting, or otherwise altering tent fabric is done at your own risk.
• Adult installation and supervision required.

By purchasing, you accept full responsibility for installation and use, and you accept that Nomad GearWorks is not liable for injury, fire, carbon monoxide exposure, or damage to your tent, heater, or other property. Full details in our Terms of Service.

Pair it with the NomadCoupler system for a complete duct-to-tent magnetic airflow solution.

🛒 Order yours now and make your tent work smarter, not harder.
Designed by Nomad GearWorks. Built for the out there.